Menu
Working hours
Store Hours:
  • 9:00-18:00

Tiger TG-ST22

  • Availability: In Stock
Brands Tiger

Tiger TG-ST22

Multifunctional car jump starter

    • Supports emergency car start (12V)
    • Convenient for charging devices of different brands with a current of 2A 5 volts
    • Supports charging mobile phones of different brands with 2A 5 volts
    • High brightness and several LED lighting modes
    • Starting at low temperatures
    • Intelligent compressor (pump) function for inflating tires with discrete adjustment to a given pressure and auto shutdown when the given pressure is reached
    Technical parameters:
    • Digital charge indicator
    • Actual capacity: 7000-8000 mAh
    • Starting current: 400 A
    • Peak current: 800 A
    • Input: 5 V / 2 A Type C
    • CE5 output: 12-16 V
    • USB output: 5 V / 2 A
    • Charging time: approximately 5 hours with a current of no more than 2 A 5 volts
    • Built-in compressor power: 90 W.
    • Premium packaging made of EVA material

    Important tips:
    1. Before starting, make sure that the electronics, air conditioning, headlights, etc. are turned off.
    2. The contacts on the positive and negative poles of the battery must be fully clamped, free of dust and rust.
    3. Check the charge of the device - it must be fully charged.
    4. During starting, the charge may fluctuate slightly - this is normal.
    5. If the battery is very weak or discharged, it is better to connect the device directly to the starter, bypassing the battery - the starting efficiency will be better.
    6. After starting, do not turn off the ignition until the battery is restored.
    7. Connect the clamps correctly (+ to +, - to -).

    Starting process:
    1. Before use, make sure that the charge level is more than 60%. If less - it is forbidden to start the car to avoid damaging the device.
    2. Connect the red clamp to the "+" of the battery, the black clamp to "-".
    3. Start the engine within 30 seconds of connecting. If it fails, reconnect and try again.
    4. Disconnect the device 20 seconds after starting and do not leave it connected for a long time.
    5. Each start attempt should not last more than 3 seconds. If it fails, wait 2-3 minutes for the device to cool down and try again.