Tiger TG-ST19

Tiger TG-ST19

Multifunctional car jump starter

• Suitable for various types of cars and trucks with an on-board voltage of 12 volts.
• Quick start, easy to use.
• Can be used to charge devices, providing timely power 2A 5 volts.
• Suitable for charging portable devices.
• Compatible with mobile phones, MP3 and MP4 players 2A 5 volts.

Technical parameters:

• Model: TG-ST19
• Size: 178.83.8 cm
• Battery type: high-speed lithium battery
• Technical parameters
• Digital charge indicator
• Actual capacity: 7000-8000 mAh
• Startup current: 400 A
• Peak current: 800 A
• Input: 5 V / 2 A Type C
• CE5 output: 12-16 V
• USB output: 5 V / 2 A
• Charging time: about 5 hours with a current of no more than 2 A 5 volts
• Convenient plastic case

Important Tips:

1. Before starting, make sure that the electronic equipment, air conditioning, headlights, etc. are turned off.

2. The metal wire on the positive and negative terminals of the battery clamp should be well connected, and the dust or rust should be cleaned first.

3. Make sure the charge is sufficient, preferably full. When driving in a car, the charge level may vary significantly, which is normal. After starting the car, the charge is restored. If the starter fails twice, be sure to disconnect the device and find out the reason before trying again. Pay attention to the temperature of the clamps and the jumper every time you use it on the road.

4. If the battery is too low or not, it is recommended to use the jumper directly without connecting to the battery line, so that the starting efficiency is higher. Disconnect the positive / negative cable of the battery. Correctly connect the positive and negative cable with clamps, and then try to jump start the battery. After starting, do not turn off the ignition, and then connect the battery line back to the original state.

Starting process:

1. Before use, make sure the battery level is at least 60%. If the battery level is less than 60%, it is forbidden to start the car (try to start the car when fully charged to extend the service life of the device).

2. Connect the positive (+) pole of the battery to the red clamp and the negative (-) pole to the black clamp, then immediately get into the car and start the engine. If a smart clamp is used, its green indicator will be on for a long time.

3. Start the car within 30 seconds, otherwise the energy of the jumper will go to the battery. If a smart clamp is used, it will automatically turn off after 30 seconds and need to be connected again.

4. Disconnect the jumper and battery clamps within 20 seconds after starting. Do not leave the clamps connected to the jumper for a long time. 5. Each start attempt should not last longer than 3 seconds. If the start fails, disconnect the device from the vehicle and wait 2-3 minutes (until the terminal protection module cools down), then try again.